Set of devices the State Standard 5960

It is the holder with spring clip for working viscometers of types VPJ 1, VPJ 2, VPJ 4, residence permit, Cannon Fenske Routine, Cannon FenskeOpaque, Ubbelohde, BS/IP/RF.

The stopper holder made of Teflon allows you to mount securely the temperature sensor of LTA electronic thermometers with a diameter of 4 mm in the 14/23-inch laboratory glassware.

Allows you to install and securely fix up to 6 verifiable thermometers with a diameter of the submerged part from 3 to 9 mm. The design of the holder eliminates damage to glass thermometers. It is designed for calibration thermostats THERMOTEST-100 and THERMOTEST-300.

It is used for determining the pour point of petroleum products in accordance with GOST 20287 (method B).

It is the holder with a screw clip for reference viscometers. It is designed for use in VIS T 06, VIS T 06 01 and VIS T 11 thermostats

The holder with flat steel springs allows you to install and securely fix up to 6 verifiable thermometers with a diameter of the submerged part from 16 to 20 mm. It is designed for calibration thermostats THERMOTEST-100 and THERMOTEST-300.

It is designed for use in CRYO VIS T 05 and CRYO VIS T 05 01 thermostats until 2016.

It is used in determining the crystallization temperature in accordance with the State Standard 18995.5.

It is intended for placing vessels with samples in the working baths of the BNTI 05 04 bath when determining the low-temperature properties of petroleum products, if appropriate test vessels are available. Suitable for placing vessels with samples for the State Standard 20287 (Method A), EN 23015 or ASTM D97.

It is used for determining the low-temperature characteristics of petroleum products in accordance with the State Standard 20287 (Method A), EN 23015 and ASTM D97

It is designed for simultaneous polishing of four copper plates measuring 75×12.5×2 mm used in determining the corrosive effect of fuels in accordance with GOST ISO 2160, GOST 32329, GOST 6321, GOST 2917 and ASTM D130.

It is used for testing in accordance with the State Standart 12801, GOST 11501, GOST 33136 and GOST 11505.

The stopper holder is made of Teflon. It allows you to mount securely the temperature sensor of the LT 300 or LT electronic thermometers in 14/23-sized laboratory glassware.

It is designed to be placed in a liquid thermostat CRYO T 05 01 and is used to determine the turbidity temperature and the beginning of crystallization of motor fuel in accordance with GOST 5066 (method B). For testing, an additional set of CRYO T 05 01 K devices is required.