measuring air-thermal installation ASESH-8-2

Implements a thermogravimetric (air-thermal) method for determining the mass fraction of moisture, based on measuring the mass of the sample of the analyzed substance before and after drying, followed by calculating the values of the mass fraction of moisture.
Air-thermal measuring installations ASESH-8 are registered in the State Register of Measuring Instruments under No. 58526-14, have a certificate of approval of the type of measuring instruments OC.C.31.005 And No. 56847.The installations undergo initial verification and have the appropriate certificate.
General characteristics:
- The presence of two independent drying chambers.
- Possibility of simultaneous determination of humidity of 12 samples:
Each drying chamber of the installation consists of 6 independent cells. You can put 2 buckets in each cell. Total capacity of the ASES Installation-8-2 – 24 bucs.
- Convenient access to the cells of the drying chamber:
On the front side of the cabinet there are four doors for access to the cells.
- Natural ventilation:
The absence of rotating elements ensures absolute noiselessness of operation and a long service life.
- Built-in timer:
The ASESH-8-2 installation has 4 timers, by means of which the end of the drying process is monitored in each section with the output of an audible signal and a light indication.
- The output to the operating mode is 30 minutes:
The power of air-thermal installations is 1200 watts. When entering the operating mode, the power consumption is the same as that of similar cabinets with low power.
SCOPE OF DELIVERY :
1. Installation of ASESH-8-2
2. AO-3 cooler
3. Auxiliary accessories
4. Air-heat control unit:
5. Interface unit for connecting a personal computer with a scale (available on request);
6. software for processing and archiving measurements of humidity determination data;
The program allows you to:
Set the operating temperature in the chambers via a personal computer
Set the necessary parameters of the sample drying process according to the selected method
Display all current processes (predrying, drying, cooling) and parameters (temperature, time) during the tests. To monitor the process by means of an electronic timer with the output of an audible signal.
Record all weighing results.
Perform humidity calculations in accordance with standardized methods. To calculate the humidity with pre-drying, the program uses formulas that allow you to get an accurate result.
Archive and print test results.

According to the test results of FSUE "UNIIM", it is recommended to use a laboratory mill of the BLIZZARD series for sample preparation.
SCOPE OF APPLICATION:
1. Crop production, agriculture and forestry.
2. Products of meat, dairy, fish, flour-milling, feed and microbiological industries.
3. Food industry products.
4. Cellulose, paper, cardboard and products made from them.
5. Medicines, chemical and pharmaceutical products and medical products.
6. Building materials.
7. Products of the logging and sawmilling and woodworking industry.
8. Ground, soils, mineral fertilizers.
Technical specifications:
The measurement range of the mass fraction of moisture, % from 0.5 to 80
Operating temperature range, °C from 45 to 160
The error of setting and maintaining the temperature in the working area, ° C, not more than 2.0
Limits of permissible absolute error, % ± 0.5
Power consumption, V• A, not more than 1200
Overall dimensions, mm 240 × 260 × 640
Overall dimensions of the cell, mm 75 x 40 x 165 (depth)
Weight, kg 28.4